Condensation and Mould in a Rented Flat: Whose Fault?

Black mould appears in the corner of a bedroom. The tenant reports it. The landlord replies that it is condensation caused by drying washing indoors and not opening windows. The tenant points out that the extractor fan has never worked and the windows have no trickle vents.

This exchange happens in thousands of British flats every winter, and until fairly recently it usually ended there. The legal position has shifted, and the shorthand answer — that condensation is the tenant's lifestyle — no longer holds up the way landlords have often assumed.

What follows is general information rather than legal advice. If you are in a serious dispute, Shelter, Citizens Advice and your council's environmental health team all give free advice on individual cases.

The Short Answer

Mould needs three things: moisture, a cold surface, and time. The tenant usually supplies some of the moisture. The building supplies the cold surface and the lack of ventilation. Responsibility follows that split.

The landlord is generally responsible for: the building fabric, insulation, any penetrating or rising damp, and providing adequate ventilation — working extractor fans, trickle vents, openable windows.

The tenant is generally responsible for: reasonable use — using the ventilation that exists, not blocking vents, heating the property to a reasonable level where they can afford to, and reporting problems promptly.

The important change: a landlord generally cannot dismiss damp as tenant lifestyle unless they can demonstrate that is the sole cause. In most cases there is a structural or ventilation contribution, and that is theirs.

Awaab's Law introduced enforceable deadlines for investigating and fixing damp and mould. Phase one took effect for social housing in England on 27 October 2025. Extension to the private rented sector is legislated for under the Renters' Rights Act 2025 but the commencement date has not been settled — check the current position rather than relying on this article.

What Actually Matters

The distinction between condensation damp and other damp. Penetrating damp comes through a defect in the fabric — a failed roof, a cracked render, a leaking gutter. Rising damp comes up from the ground. Both are unambiguously the landlord's. Condensation damp forms when humid indoor air meets a cold surface, and that is the one that gets argued about.

Where it appears tells you a great deal. Condensation mould shows up on the coldest surfaces: external wall corners, window reveals, behind furniture against outside walls, in north-facing rooms. Penetrating damp appears in a patch that relates to a defect outside and is usually worse after rain. A surveyor can distinguish them; so, often, can you.

Ventilation provision is a building matter. Whether a bathroom has a working extractor, whether windows have trickle vents, whether a kitchen has any mechanical extraction at all — these are the landlord's to provide. A tenant cannot ventilate a flat that has no means of ventilation.

Detailed Analysis

Where the moisture comes from

Worth quantifying, because the argument is usually conducted without numbers.

A household of two produces a substantial amount of water vapour daily through breathing, cooking, showering and washing. Drying one load of laundry indoors adds roughly two litres on top of that.

So the tenant's activities do genuinely put moisture into the air. That much of the landlord's argument is true.

What it misses is that all of those activities are normal occupation. Cooking, washing and breathing are not lifestyle choices. A dwelling is expected to handle the moisture generated by living in it, and the means of handling it — ventilation — is part of the building.

Where a tenant's conduct does become relevant is at the margins: blocking an air brick, permanently closing trickle vents, disabling an extractor fan, or drying large volumes of washing in an unventilated bedroom with the door shut. Those are specific, identifiable behaviours rather than a general accusation.

What the building contributes

The other half of the equation, and the half tenants are usually less able to change.

Cold surfaces. Uninsulated solid walls run several degrees colder than insulated cavity walls. Single glazing runs colder still. Thermal bridges at junctions and lintels create localised cold spots, and those are exactly where mould appears first. None of this is within a tenant's control.

Ventilation provision. Part F of the Building Regulations sets standards for ventilation in new and refurbished dwellings — extract fans in kitchens and bathrooms, background ventilation such as trickle vents. Older properties may predate those requirements, but a landlord still has to provide a home fit for habitation.

Heating. A property that cannot be heated to a reasonable temperature affordably will have cold surfaces regardless of what the tenant does. Excess cold is itself a recognised hazard under the Housing Health and Safety Rating System.

The practical test a tenant can apply: is there a working extractor in the bathroom and kitchen, and can windows be opened for background ventilation? If the answer to either is no, the ventilation provision is inadequate and that is the landlord's responsibility to fix.

The legal position, as it stands

Several strands overlap here.

The Homes (Fitness for Human Habitation) Act 2018 requires rented homes in England to be fit for human habitation at the start of and throughout the tenancy. Freedom from damp is one of the matters taken into account. This applies to private tenancies now and is the main route for a private tenant.

The Housing Health and Safety Rating System is what a council's environmental health team uses to assess hazards, and damp and mould growth is a recognised category. A serious hazard can lead to an improvement notice.

Awaab's Law came into force for social housing in England on 27 October 2025, imposing enforceable timescales for investigating and making safe damp and mould hazards. The Renters' Rights Act 2025 provides for extending this to the private rented sector, but the commencement date for that extension was not settled at the time of writing and expectations have shifted more than once. If you are relying on it, check the current position.

The lifestyle defence has narrowed. The direction of both the legislation and the accompanying guidance is that landlords should not attribute damp and mould to tenant lifestyle unless they can demonstrate that is the sole cause. In practice a structural or ventilation contribution is usually present, which means the responsibility is usually at least shared.

Building a record that stands up

This is the part a tenant can do something about immediately, and it matters more than any argument about causation.

Report in writing and date it. Email, not a phone call. Describe where the mould is, when it appeared, and what the conditions are.

Photograph it, with something for scale and a visible date. Repeat monthly. A sequence showing growth over a winter is far more persuasive than one image.

Record what you do. A brief note of your routine — which room you dry washing in, that the window is open, that the extractor runs — pre-empts the lifestyle argument rather than responding to it.

Note what does not work. An extractor fan that does not move air, a window that will not open, a trickle vent that is painted shut. Test the fan by holding a sheet of tissue to the grille; if it does not hold, the fan is not extracting.

Buy a cheap hygrometer. A few pounds, and it turns "the flat feels damp" into a relative humidity figure. Persistent readings above about 70% indicate a genuine problem rather than an impression.

What a tenant can reasonably do

Reducing the moisture load is worth doing on its own terms, and it also strengthens your position by removing the arguments available to the other side.

Use the ventilation that exists, even when it is cold. Keep trickle vents open. Run the extractor during and after showering and cooking, and for a while afterwards. Keep lids on pans.

Dry washing in one room with the door shut and a window open, rather than spreading it through the flat — the full method is in how to dry washing in a flat with no outdoor space and drying clothes indoors without causing damp.

Spin laundry at the highest speed the fabric allows, which removes water mechanically before it can become airborne.

Leave a gap behind furniture on external walls. A wardrobe flat against a cold wall creates an unventilated cold pocket, and that is one of the most common mould locations in a flat.

A dehumidifier genuinely helps, and if you are drying indoors all winter it is worth having regardless of who is ultimately responsible for the building.

Real-World Considerations

Modern flats can be worse than older ones, which surprises people. A well-sealed building has very little accidental ventilation, so moisture put into it stays. Retrofitted insulation and new windows without adequate ventilation have created damp problems in properties that never had them before.

Affordability is relevant and often unspoken. Advice to "heat the property adequately" assumes that is possible. A tenant on a prepayment meter in a poorly insulated flat may be making a rational choice they cannot avoid, and excess cold is itself a recognised hazard rather than a tenant failing.

Deposit disputes are where this frequently surfaces. Landlords sometimes seek deductions for mould damage at the end of a tenancy. Adjudicators generally look for evidence of the cause, and a tenant with dated photographs, written reports and a record of their routine is in a considerably stronger position than one without.

Retaliatory eviction is a real concern and there is some protection against it. In England, where a council serves an improvement notice after a tenant has complained, a landlord's ability to serve a section 21 notice can be restricted. The rules are detailed and changing, which is a reason to take advice rather than rely on a summary.

Cleaning mould off does not solve anything if the moisture source remains. It will return in the same place, usually within weeks. Treating it is worth doing for health and appearance; it is not a fix and should not be presented as one by either party.

Common Mistakes Buyers Make

  • Reporting it verbally. No date, no record, and nothing to escalate from.
  • Accepting "it's condensation" as the end of the conversation. Condensation damp still has a building contribution in most cases.
  • Not testing the extractor fan. Many do not move air. A sheet of tissue settles it in five seconds.
  • Blocking trickle vents because of draughts. Understandable and it removes the background ventilation the building was designed around.
  • Pushing furniture flat against external walls. Creates the unventilated cold pocket where mould starts.
  • Cleaning it off and saying nothing. It returns, and you have no record of how long it has been happening.
  • Drying washing in a closed bedroom. The worst combination available — high moisture, no ventilation, cold external walls.
  • Withholding rent over it. Converts a repair dispute into a possession risk.

Alternatives Worth Considering

A dehumidifier is worth having regardless of the dispute. It reduces the moisture load directly, costs well under 50p for a six-hour run, and it demonstrably shows what would otherwise be condensing on the walls.

A hygrometer at a few pounds converts an argument into a measurement. Readings persistently above 70% relative humidity support a case; readings in the 40s and 50s suggest the problem is a cold surface rather than excess moisture.

Environmental health is free, and their assessment carries weight that a tenant's does not. They are the route most likely to produce action where a landlord is unresponsive — see who is responsible for repairs in a rental for how that escalation works generally.

And Shelter's guidance on damp and mould is current, free, and written for exactly this situation. For anything contested, it is a better source than any general article including this one.

Frequently Asked Questions

Is condensation the tenant's fault?

Rarely entirely. Tenants produce moisture through normal occupation; the building supplies the cold surfaces and the ventilation. Responsibility usually reflects both.

Can a landlord blame damp on lifestyle?

Only where they can demonstrate that is the sole cause. In most cases there is a structural or ventilation contribution, which is theirs.

Does Awaab's Law apply to private renting?

Not yet in the same form. Phase one applies to social housing in England from 27 October 2025, and extension to the private sector is legislated for but the commencement date has not been settled. Check the current position.

What should you do first about mould in a rental?

Report it in writing with dated photographs, and record what ventilation exists and whether it works.

Can you be evicted for complaining about damp?

There is some protection against retaliatory eviction in England where the council has served an improvement notice. The rules are detailed — take advice.

Does drying washing indoors cause mould?

It adds moisture, around two litres per load. Whether that becomes mould depends on whether the building can ventilate it away.

Final Thoughts

The framing that causes most of the trouble is treating this as a question with one answer. Mould needs moisture and a cold surface, and in a rented flat those two things usually have different owners.

The practical position for a tenant is to do the reasonable things — use the ventilation, dry washing sensibly, leave gaps behind furniture — and to document all of it. That reduces the problem and removes the argument at the same time.

Then report in writing, keep dated photographs, and go to environmental health if nothing happens. For the drying side specifically, which is the part most within your control, see drying washing in a flat.

Post a Comment

Previous Post Next Post